This LM48511SQDB is an evaluation board designed to ease the evaluation and effort during the development of a circuit using the LM48511SQ. It is an easy to use stand-alone board that requires power and GND, an input signal and an output load.
The TPS54140EVM-429 evaluation module is designed to demonstrate the small printed-circuit-board areas that may be achieved when designing with the TPS54140 regulator. The TPS54140 dc/dc converter is designed to provide up to a 1.5 A output from an input voltage source of 3.5 V to 42 V. Rated input voltage and output current range for the evaluation module are given in Table 1. The switching frequency is externally set at a nominal 500 kHz.
This EVM features the DAC8801 multiplying digital-to-analog converter (MDAC). It provides a quick and easy way to evaluate the functionality and performance of the high-resolution serial input MDAC. The EVM provides a serial interface header to easily attach to any host microprocessor or TI TMS320 DSP family base system for communications.
The Texas Instruments TPS542941EVM-057 evaluation module (EVM) helps designers evaluate the performance of the TPS542941 2A/3A Output, 18V, Dual Synchronous Step-Down Converter.
The SN65LVDS250 is a 4 x 4 non-blocking Cross Point switch. Low-Voltage differential signaling (LVDS) is used to achieve signaling rates of greater than 2.0 Gbps per channel. Each output driver includes a 4:1 multiplexer to allow any input to be routed to any output. Internal signal paths are fully differential to achieve the high signaling speed while maintaining low signal skews. The SN65LVDS250 LVDS driver output characteristics are complaint with the requirements of the TIA/EIA-644-A standard.
The TPS2056AEVM-293 is an evaluation module (EVM) for the Texas Instruments family of two-channel, current-limited, power-distribution switches. This EVM operates over a 2.7 V to 5.5 V range and provide a continuous output current of up to 1.5 A. Test points provide convenient access to all critical node voltages.
The Texas Instruments TPS54262EVM evaluation module (EVM) helps designers evaluate the operation and performance of the TPS54262 Switch Mode Power Supply - Buck Regulator. The device offers configurability and can be setup to switch from 200KHz up to 2.2MHz.
CAUTION: This equipment operates at high voltages and currents which can result in hazardous electrical shock. Please make sure you understand and follow all necessary safety precautions prior to purchasing and operating.
There are three switches on the evaluation board. SW1 and SW2 provide the designer with the flexibility of evaluating the performance of the UCC3918 when residing on either the system backplane or on an adapter card. Closing SW1 after SW2 simulates an application where the UCC3918 resides on a plug-in adapter card. Closing SW1 prior to SW2 simulates an application where the UCC3918 resides on the system backplane. SW3 provides a shutdown input to disable the IC.
The TSC2017EVM-PDK is a complete evaluation/demonstration kit for the TSC2017 4-wire, resistive touch screen controller (TSC), which can be connected to a PC through a USB cable and controlled by PC GUI software. The TSC2017EVM-PDK includes (1) a TSC2017EVM, (2) a USB-MODEVM, and (3) a CD-ROM with evaluation software installer for the PC and related documentation.